Services

Our expert leak detection service entails a three-step process

Step One

We begin with an extensive inspection of your swimming pools plumbing and surface area.

Step Two

We will then proceed with a dye test and an ultrasonic listening device that is specifically designed to pinpoint the existence of a swimming pool leak.

Step Three

Once the location of the leak has been determined, the leak repair specialists at DFW Leak Detection will find a solution that will be in the very best interest of your swimming pool.

Always be aware of the signs of a possible leak.
Below are some indicators that you might have leak

If you are loosing more than an 1/8" in 24 hours?

Then you may have a leak


Do you see you algae build-up, but you have recently chemically treated your pool?

If so, you may have a leak!


Do you have loose or fallen tiles from your swimming pools surface? How about cracks in your pools deck?

If so, you may have a leak.


Do you have a mushy ground, standing water or uneven grass growth around the swimming pool?

this may be a result of your automatic filter constantly releasing water.


Cracks in the pools shell?

should be repaired immediately.


Bubbles in the pump

can also be a result of a leak in the main drains and skimmers. Leaks in the main drains should be immediately repaired. They can be detrimental to your swimming pool and life-threatening to your beloved swimmers.

The Bucket Test:

The "Bucket Test" will determine if water loss in a pool is due to evaporation or a leak:
  1. Bring pool water to normal level.
  2. Fill bucket with pool water to about one inch from top.
  3. Place bucket on first or second step of pool.
  4. Mark water level on inside of bucket.
  5. Shut off pump and mark pool level on outside of bucket.
  6. Resume normal pump operation.
  7. After 24 hours, compare the two levels. If the pool water (outside mark) goes down more than the inside water level, there is probably a leak.
  8. In case of rain, repeat the test.
  9. Test is not valid after 24 hours.

Calculating Water Loss:

How much water is your swimming pool losing?

It takes .62 gallons of water to cover 1 sq. ft. 1" deep.

An Example: A 16' x 32' pool drops 1"

Area = 512 sq. ft. multiplied by .62 = 317.44 gallons